Grey roller blind with a sheer S-fold curtain layered in front, in a bedroom

How much depth do you need to layer blinds, curtains and shutters?

The short answer

Add up each layer, plus a gap

To layer a curtain in front of a blind or shutter, add the depth of each layer and leave at least 10mm between them. That total is how far the layers sit out from the wall, or the clear depth you need inside a pelmet or bulkhead.

These depths are for face fitting. They apply when every layer is face fitted to the wall or ceiling, and nothing can go inside the recess.

  • 70mmSingle roller blind
  • 90mmDouble roller blind
  • 50mmPlantation-style shutters (face fit)
  • 90mmPinch pleat curtain
  • 110mmS-fold curtain
  • 10mmMinimum gap between layers

Example: a single roller blind with an S-fold curtain in front needs at least 190mm (70mm + 10mm + 110mm).

Quick reference

Depth to allow

1. What's at the back?
2. What's in front?

Depth to allow

190mm

70mm + 10mm gap + 110mm

Have more room? With a 20mm gap, allow 200mm.

See every pairing in one table
Back layerFront layerDepth to allow
Single roller blind
Single roller blind 70mmPinch pleat curtain 90mm170mm70 + 10 + 90
Single roller blind 70mmS-fold curtain 110mm190mm70 + 10 + 110
Double roller blind
Double roller blind 90mmPinch pleat curtain 90mm190mm90 + 10 + 90
Double roller blind 90mmS-fold curtain 110mm210mm90 + 10 + 110
Plantation-style shutters (face fit)†
Shutters 50mmPinch pleat curtain 90mm150mm50 + 10 + 90
Shutters 50mmS-fold curtain 110mm170mm50 + 10 + 110
Two curtains on a double track
Pinch pleat curtain 90mmPinch pleat curtain 90mm190mm90 + 10 + 90
Pinch pleat curtain 90mmS-fold curtain 110mm
(or the other way round)
210mm90 + 10 + 110
S-fold curtain 110mmS-fold curtain 110mm230mm110 + 10 + 110

Note: every pairing allows at least 10mm between the two layers. The more room between them, the better: 20mm is ideal.

†Shutter panels swing open into the room. Draw the curtain back clear of the panels before you open them, or allow extra room if you can.

Check for obstructions before you order. Air conditioners, vents, power outlets, light switches, cornices and window handles can all get in the way of a face-fitted pairing.

Each total is how far the layers sit out from the wall, or the clear depth you need inside a pelmet or bulkhead. If your blind can go inside the recess instead, it needs 70mm of recess depth (90mm for a double roller), and only the curtain sits out from the wall.

Good to know

Before you order

Face-fitted blind?

Choose extension brackets (about 160mm) for the curtain track. A standard bracket sits about 70mm out, which won't clear the blind. Read more

Check for obstructions

Look around the window for anything the layers could hit: air conditioners, vents, power outlets, light switches, cornices, handles or winders. Measure your depth at both ends and in the middle, and use the smallest figure.

Short on room?

Choose pinch pleat over S-fold, put the blind inside the recess, or fit the curtain track to the ceiling. Ceiling fixing

Not sure it'll fit? Send a photo and your measurements to info@curtainandblindco.com.au or call 1300 301 368. We'd rather check it now than see you re-order later.